Müller-ElektronikECU-Mini controller
In stock
ECU-Mini is prepared for the use on utility vehicles and machines. The communication with a virtual terminal like Basic-Terminal, Basic-Terminal TOP or Comfort-Terminal runs on the standardized CAN network (ISO 11783). With an optional 2nd CAN interface (J1939) it is possible to use it as a CAN bridge.
The gateway ECU is equipped with a 16-bit central prosessing unit (CPU).
Actuators and sensors are connected to a 42-pin connector via a cable loop, which consists of corrugated tubes. Diagnostic functions are available for all in- and outputs, which are protected against short circuits to ground or operating voltage. The gateway ECU supplies the power for the sensors at the 42-pin connector. All inputs for revolution sensors can be configured for sensors switching operating voltage or GND.
Technical data ECU-Mini
| Power supply: | 10 V to 16 V (including load dump protection up to 80 V) |
| Current (power on): | 100 mA (without power output and power supply of external sensors) |
| Reference voltage: | 5 V/100 mA |
| CPU: | C167 16 bit (Infineon or ST) |
| RAM: | 128 KiB |
| Flash memory | 512 KiB (programmable via RS-232 interface) |
| EEPROM | 2 KiB (FRAM, ten years data security) |
| Temperature range: | −20 °C to +70 °C (according to IEC 68-2-14-Nb, IEC 68-2-30 and IEC68-2-14Na) |
| Housing: | Closed aluminum box, varnished aluminum top with gasket, stainless steel screws |
| Protection category: | IP65K (according to DIN 40050) |
| EMC: | According to ISO 14982 / PREN 55025 Level 4 |
| Environmental test: | Vibration- and impact test according to IEC 68-2 |
| Measurements: | 140 mm × 140 mm × 45 mm |
| Weight: | 0,5 kg |
| Connectors: | 42-pin plug (counterpart lockable and with separate seals for each wire to connect actuators and sensors) |
| Interfaces: |
• 2 CAN • 1 RS-232 (RX- and TX-Data) |
| Outputs: |
• 6 power outputs up to 4 A perm. current + current measurement • 2 power outputs up to 4 A perm. current + current measurement (optional) • 2 analog outputs (100 mA) (PWM optional) |
| Inputs: |
• 4 analog inputs • 4 analog inputs (optional) • 10 static inputs |