Müller-ElektronikECU-Midi controller
In stock
The ECU-Midi is prepared for the use on utility vehicles and machines. The communication with a virtual terminal like Basic-Terminal, Basic-Terminal TOP or Ccomfort-Terminal runs on the standardized CAN network (ISO 11783). The electronic control unit is equipped with a 16-bit CPU-card with flash memory. Software updates and configuration files can be downloaded across CAN.
Actuators and sensors are connected to one up to three 42-pin connectors via a cable loop, which consists of corrugated tubes. Diagnostic functions are available for all in- and outputs, which are protected against short circuits to ground or operating voltage. The electronic control unit supplies the power for the sensors at the 42-pin connectors. All inputs for revolution sensors can be configured for sensors switching operating voltage or GND.
Technical data ECU-Midi
| General: | |
| CPU: | 16-bit Fujitsu MB 90F345 with Flash-memory |
| Memory: | Flash 512 KiB; RAM 20 KiB; 64 kbit I2C-Bus EEPROM |
| Connections: |
• 1 16-pin plug for power supply, CAN (J1939 or ISO 11783) and V24 • (option for cascading multiple Electronic Control Units) • 42-pin plug for sensors and actuators |
| Powersupply: | 10 VDC to 16 VDC or 19,2DC to 32 VDC (optional with switching power supply for 10 V to 32 V) |
| Current (Power On): | 350 mA (at 13,8 V without power output and power supply of external sensors) |
| Temperature range: | −20 °C to +70 °C (according to IEC68-2-14-Nb, IEC68-2-30 and IEC68-2-14Na) |
| Housing: | closed aluminum box, varnished aluminum top with gasket, stainless steel screws |
| Protection category: | IP66K (according to DIN 40050-9 1993) |
| Environmental test: | Vibration- and impact test according to IEC68-2 |
| Measurements: | 282 mm × 143 mm × 57 mm |
| Weight: | 0,95 kg |
|
|
| 16-pin plug | • Power supply (electronic and power separate) • CAN network according to J1939 or ISO 11783 (version with only one 16-pin connector with termination network) • 2 revolution inputs |
| Second 16-pin plug | Internal connection between 1st and 2nd 16-pin plug • Power supply (electronic and power separate) • CAN network according to J1939 or ISO 11783 |
|
|
42-pin plug |
|
| Inputs: |
• 25 for analog NPN- or PNP-sensors, four of these as 4 mA to 20 mA possible |
| Outputs: |
• 2 Lowside 1,7 A • 18 Highside and/or Lowside 5,5 A • 2 Highside 5,5 A, 2 Highside and/or Lowside 12 A |